Removal - 2.0L/2.4L
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DO NOT REMOVE PRESSURE CAP OR ANY HOSE WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.
- Partially drain cooling system below thermostat level.
- Disconnect hoses at coolant outlet connector.
- Remove bolts attaching coolant outlet connector. See Fig 1.
- Remove coolant outlet connector and thermostat.
| 1 - PRESSURE CAP |
| 2 - COOLANT OUTLET CONNECTOR |
| 3 - THERMOSTAT HOUSING |
| 4 - ENGINE COOLANT TEMPERATURE SENSOR |