LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System - Except Coupe) >> Engine >> Engine Block Heater >> Installation >> Installation - 2.0L/2.4L

Installation - 2.0L/2.4L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean core hole and heater seat.
  2. Insert heater assembly with element loop positioned upward   . See Figure.
  3. With heater seated, tighten center screw securely to assure a positive seal.
    CAUTION: To prevent damage, the power cord must be secured in it's retaining clips, and not positioned so it could contact linkages or exhaust manifold.
  4. Connect power cord to heater.
  5. Lower vehicle.
  6. Fill cooling system (Refer to COOLING/ENGINE - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals