LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System - Except Coupe) >> Engine >> Coolant Outlet Connector >> Removal >> 2.7L Engine

2.7L Engine

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system (Refer to COOLING/ENGINE - STANDARD PROCEDURE) .
  2. Remove upper intake manifold. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL) .
  3. Disconnect engine coolant temperature (ECT) sensor connector.
  4. Disconnect hoses at coolant outlet connector. Use Special Tool 8495 Pliers to remove clamps. See Fig 1.
    Fig 1: Hose Clamp Pliers 8495
    GC0019839Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove bolts attaching coolant outlet connector. See Fig 2.
  6. Remove coolant outlet connector.
Fig 2: Coolant Outlet Connector - 2.7L
GC0031148Courtesy of DAIMLERCHRYSLER CORP.
1 - BOLT (2)
2 - BOLT (2)
3 - COOLANT OUTLET CONNECTOR
scientia non olet · About LEMON Manuals