Description - Shock Assembly

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The rear shock absorber assemblies support the weight of the vehicle using coil springs positioned around the shock absorbers. The coil springs are contained between the upper mount of the shock absorber and a lower spring seat on the body of the shock absorber.

The top of each shock absorber assembly is bolted to the top of the inner fender through a microcellular urethane isolated mount.

The bottom of the shock absorber assembly attaches to the rear knuckle using a thru-bolt.

The rear coil springs are rated separately for each corner or side of the vehicle depending on optional equipment and type of vehicle service. Coil springs come in a various rates; be sure the correct spring is in use.

The components of the shock assembly listed below are serviceable:

Shock rod nut
Shock mount
Shock rod bushings
Upper spring isolator
Dust shield
Cup
Jounce bumper
Lower spring isolator
Coil spring
Strut