LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Suspension System - Except Coupe) >> Rear Suspension >> Hub / Bearing >> Installation

Hub / Bearing: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hub and bearing assembly on the knuckle spindle. Install a NEW retaining nut. Tighten the retaining nut to a torque of 250 N.m (185 ft. lbs.).
  2. Install the hub and bearing dust cap using a soft faced hammer.
  3. If equipped with rear disc brakes, install the brake rotor and caliper. (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTOR - INSTALLATION)
  4. If equipped with rear drum brakes, install the drum and adjust brake shoes as necessary. (Refer to BRAKES/HYDRAULIC/MECHANICAL/DRUM - INSTALLATION)
  5. Install the rear tire and wheel assembly. Progressively tighten all wheel stud nuts in crisscross pattern to 135 N.m (100 ft. lbs.) torque.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals