LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Suspension System - Except Coupe) >> Front Suspension >> Stabilizer Bar >> Installation >> Installation - Stabilizer Bar

Installation - Stabilizer Bar

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position stabilizer bar and bushings as an assembly into front crossmember. Install the stabilizer bar bushing retainer to crossmember and body attaching bolts. See Figure.
  2. Tighten the bushing retainer attaching bolts to a torque of 61 N.m (45 ft. lbs.).
  3. Align stabilizer bar attaching link assemblies with attaching link mounting holes in the lower control arms. Install stabilizer bar attaching links into both lower control arms. Install the attaching link to lower control arm retaining nuts. Torque the stabilizer bar attaching link nuts to 105 N.m (77 ft. lbs.).
scientia non olet · About LEMON Manuals