LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Seat Belt Control Timer Module - Convertible Jr27 - Export >> Removal

Seat Belt Control Timer Module - Convertible Jr27 - Export: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the drivers seat to its full forward position.
  2. Disconnect and isolate the battery negative remote cable.
  3. Using a razor knife or equivalent, cut the carpet a small amount (about an inch or so) to access the Seat Belt Control Timer Module (SCTM).
  4. Disconnect the electrical connector.
  5. Remove the two screws retaining the SCTM.
  6. Remove the SCTM from the vehicle.
scientia non olet · About LEMON Manuals