LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Rear Seat Belt & Retractor - Convertible Jr27 Only >> Removal

Rear Seat Belt & Retractor - Convertible Jr27 Only: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove rear seat cushion. Refer to REMOVAL .
  3. Remove rear seat back. Refer to REMOVAL .
  4. Remove quarter trim panel. Refer to REMOVAL .
  5. Remove bolt attaching seat belt anchor to floor pan. See Fig 1.
    Fig 1: Rear Seat Belt And Retractor
    GC0032219Courtesy of DAIMLERCHRYSLER CORP.
    1 - SEAT BELT RETRACTOR
    2 - REAR SEAT BELT SUPPORT
    3 - TAB
    4 - A
    5 - LOWER ANCHOR
  6. Remove bolt attaching seat belt retractor to rear seat support assembly.
  7. Remove rear seat belt and retractor assembly from vehicle.
scientia non olet · About LEMON Manuals