LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Passenger Airbag >> Removal

Passenger Airbag: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

If the airbag has been deployed, the instrument panel and pad assembly must be replaced.

  1. Disconnect and isolate the battery negative remote cable.
  2. Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  3. Open and lower glove box fully to gain access to Passenger Airbag attaching screws inside of the glove box. Glove box removal not required.
  4. Disconnect wire connector from the Passenger Airbag.
  5. Remove the two nuts and two screws attaching airbag assembly to the instrument panel collar. The two nuts are on the outer sides of the passenger airbag, underneath and up near the top of the instrument panel. It is a good idea to remove the center bezel with the HVAC control head to gain access to line up the socket on the stud on the inboard side of the passenger airbag. The two screws are mounted straight through the tabs at the bottom front of the airbag, in the instrument panel reinforcement.
  6. Disengage airbag door tabs from the instrument panel retainer and lift the Passenger Airbag up and out of panel cavity.
scientia non olet · About LEMON Manuals