LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Front Seat Belt Buckle - Convertible Jr27 Only >> Installation

Front Seat Belt Buckle - Convertible Jr27 Only: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the black spacer washer is properly installed over the shoulder of the weld nut on the seat adjuster.
  2. Install seat belt buckle to bolt on seat adjuster.
  3. Verify that the seat belt buckle is sitting on the shoulder of the weld nut on the seat adjuster.
  4. Install nut to hold seat belt buckle to seat adjuster. Tighten the seat belt buckle nut to 45 N.m (33 ft. lbs.) torque.
    NOTE: Verify that a minimum of three threads extend beyond the seat belt buckle nut. If not, check that the bolt is fully engaged to the seat adjuster.
  5. Connect the electrical connectors to the seat belt buckle.
    WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE REMOTE TERMINAL. REFER TO DIAGNOSIS AND TESTING - AIRBAG SYSTEM  FIRST. FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.
  6. Readjust the seat.
scientia non olet · About LEMON Manuals