Curtain Airbag: Removal
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative remote cable.
- Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
- Remove the Headliner. Refer to REMOVAL .
- Disconnect the wire harness connector from the rear of the inflator.
- Remove the retaining bolt to the front tether at the instrument panel on the A-pillar.
- Remove the five short retaining bolts along the roof line.
- Remove the four long retaining bolts to the rear along the roof line and at the C-pillar.
- Remove all push fasteners and discard. Make sure they are completely removed.
- Remove the curtain airbag from the vehicle.