Child Tether Upper Cover: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The cover is not reusable. If removed, a new one must be reinstalled. There should be no reason to reuse an old one as a new shelf panel will come with a new cover plate on it.

Place the Child Tether Cup cover into position on top of the rear shelf trim panel.
Place the push fastener on the underside of shelf trim panel on the pivot pin and push together.