LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Vibration Damper >> Installation

Vibration Damper: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install damper using Special Tools 8179 Screw, with Nut and Thrust Bearing from 6792, and 6792-1 Installer. See Fig 1.
  2. Install damper center bolt. Tighten center bolt to 170 N.m (125 ft. lbs.).
  3. Install accessory drive belts (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
  4. Install belt splash shield and right front wheel.
  5. Lower vehicle.
  6. Connect negative battery cable.
Fig 1: Vibration Damper- Installation
GC0015344Courtesy of DAIMLERCHRYSLER CORP.
1 - VIBRATION DAMPER
2 - SPECIAL TOOL 6792-1
3 - SPECIAL TOOL 8179
scientia non olet · About LEMON Manuals