LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Rocker Arms >> Installation

Rocker Arms: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate rocker arms with clean engine oil before installation.
  2. Rotate engine until cam lobe is on its base circle (heel) of rocker arm being installed.
  3. Using Special Tools 8215-A and 8216-A Adaptor, depress valve spring only enough to install rocker arm. See Figure.
  4. Install rocker arm in original position (if reused) over valve and lash adjuster. Release tension on valve spring.
    NOTE: Inspect rocker arm for proper engagement into lash adjuster and valve tip.
  5. Repeat procedure for each rocker arm being installed.
  6. Install cylinder head cover(s). Refer to procedure in this section.
scientia non olet · About LEMON Manuals