LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Rear Mount >> Installation

Rear Mount: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position rear mount on suspension crossmember and loosely install bolts.
  2. Position mount bracket on transaxle and install bolts. Tighten to 95 N.m (70 ft. lbs.). See Figure.
  3. Tighten rear mount to crossmember bolts to 61 N.m (45 ft. lbs.)
    NOTE: Be sure the weight of the engine is static and in rest position.
  4. Install rear mount to bracket through bolt and tighten to 75 N.m (55 ft. lbs.). See Figure.
  5. Tighten front mount through bolt to 75 N.m (55 ft. lbs.). See Figure
  6. Lower vehicle. Install throttle body air inlet hose and air cleaner housing assembly.
scientia non olet · About LEMON Manuals