LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Intake Manifold >> Removal >> Removal - Intake Manifold Upper

Removal - Intake Manifold Upper

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Remove throttle body air inlet hose and air cleaner housing assembly.
  3. Remove throttle cable shield. Remove throttle and speed control cables from throttle arm and bracket.
  4. Remove throttle cable bracket.
  5. Disconnect electrical connectors from the following components:
    1. Manifold Absolute Pressure (MAP) Sensor
    2. Throttle Position Sensor (TPS) Sensor
    3. Idle Air Control (IAC) Motor
  6. Disconnect Vapor Purge hose, Brake Booster hose, Speed Control Servo, Positive Crankcase Ventilation (PCV) hose.
  7. Loosen upper fastener at throttle body support bracket.
  8. Remove manifold attaching bolts. See Figure.
  9. Remove upper manifold. See Fig 1.
  10. Inspect manifold. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSPECTION) 
Fig 1: INTAKE MANIFOLD - UPPER
GC0032160Courtesy of DAIMLERCHRYSLER CORP.
1 - BOLT
2 - INTAKE MANIFOLD - UPPER
scientia non olet · About LEMON Manuals