LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Front Mount >> Installation

Front Mount: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position front mount on lower radiator crossmember.
  2. Loose install front mount to bracket through bolt.
  3. Install front mount vertical bolts. Tighten bolts to 61 N.m (45 ft. lbs.). See Figure.
    NOTE: Be sure the weight of the engine is static and in rest position.
  4. Tighten the rear mount horizontal through bolts to 75 N.m (55 ft. lbs.). See Figure
  5. Tighten the front mount horizontal through bolts to 75 N.m (55 ft. lbs.). See Figure.
  6. Install the starter solenoid heat shield.
  7. Lower vehicle.
scientia non olet · About LEMON Manuals