LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Cylinder Head Cover - Right >> Removal

Cylinder Head Cover - Right: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Remove upper intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL)  .
  3. Disconnect electrical connectors from ignition coils and capacitor. Reposition electrical harness.
  4. Remove make up air hose from cylinder head cover grommet.
  5. Remove ground strap from cylinder head cover stud.
  6. Disconnect electrical harness retaining clips from cylinder head cover studs. Reposition electrical harness.
  7. Remove fastener attaching ignition coil capacitor.
  8. Remove ignition coils.
  9. Loosen all cylinder head cover fasteners. See Figure.
    NOTE: Cylinder head cover attaching bolts are captured to the cover.
    CAUTION: Make certain the double ended studs in the center of the cylinder head cover are loose before attempting to remove cover. See Figure.
  10. Remove cylinder head cover.
scientia non olet · About LEMON Manuals