LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Cylinder Head Cover - Left >> Installation

Cylinder Head Cover - Left: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets as necessary. See Figure.
  2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations as shown in Figure.
  3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 N.m (105 in. lbs.).
  4. Install ignition coils.
  5. Install ignition coil capacitor and fastener.
  6. Connect all electrical connectors and harness clips.
  7. Install ground strap to cylinder head cover stud.
  8. Install upper intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION)  .
  9. Connect negative battery cable.
scientia non olet · About LEMON Manuals