LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Camshaft(S) >> Removal

Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe): Camshaft(S): Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the primary timing chain. (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - REMOVAL) 
  2. Remove secondary chain tensioner mounting bolts.
    NOTE: Camshaft bearing caps have been marked during engine manufacturing. For example, number one exhaust camshaft bearing is marked "1E>"
  3. Slowly loosen camshaft bearing cap bolts in reverse order of installation. See Fig 1.
  4. Remove camshaft bearing caps.
  5. Remove camshafts, secondary chain, and tensioner together as an assembly.
  6. Remove tensioner and camshaft chain from camshafts.
  7. Inspect camshafts. (Refer to ENGINE/CYLINDER HEAD/CAMSHAFT(S)  - INSPECTION)
Fig 1: Camshaft Bearing Cap Tightening Sequence
GC0015285Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals