LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Air Cleaner Housing >> Removal

Air Cleaner Housing: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Disconnect inlet air temperature sensor electrical connector. See Fig 1.
    Fig 1: INLET AIR TEMPERATURE SENSOR
    GC0032140Courtesy of DAIMLERCHRYSLER CORP.
  3. Disconnect fresh air makeup hose from throttle body air inlet hose. See Fig 2. Loosen clamp at throttle body. See Fig 3.
    Fig 2: MAKE UP AIR HOSE
    GC0032142Courtesy of DAIMLERCHRYSLER CORP.
    Fig 3: HOSE CLAMP
    GC0032141Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove hose from throttle body.
  5. Remove nut on bracket that holds air cleaner housing.
  6. Pull air cleaner housing straight up off of locating pins.
scientia non olet · About LEMON Manuals