LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (2.4L DOHC Engine (Service Information) - Except Coupe) >> Rear Mount >> Removal

Rear Mount: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove throttle body air inlet hose and air cleaner housing assembly.
  2. Remove three vertical bolts attaching rear mount bracket to transaxle case. See Fig 1.
  3. Raise vehicle on hoist.
  4. Remove rear mount bracket through bolt. See Fig 1.
  5. Loosen front mount through bolt.
  6. Remove horizontal bolt attaching rear mount bracket to transaxle case. See Fig 1.
  7. Remove mount bracket.
  8. Remove rear mount to suspension crossmember attaching bolts.
  9. Remove rear mount.
Fig 1: Engine Mounting-Rear
GC0032108Courtesy of DAIMLERCHRYSLER CORP.
1 - REAR TORQUE BRACKET
2 - REAR MOUNT
3 - THROUGH BOLT
scientia non olet · About LEMON Manuals