LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (2.4L DOHC Engine (Service Information) - Except Coupe) >> Oil Pump >> Assembly

Oil Pump: Assembly

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble pump, using new parts as required. Install the inner rotor with chamfer facing the cast iron oil pump cover. 
  2. Prime oil pump before installation by filling rotor cavity with engine oil.
  3. Install cover and tighten screws to 12 N.m (105 in. lbs.).
    CAUTION: Oil pump pressure relief valve must be installed as shown in Figure or serious damage may occur.
  4. Install relief valve, spring, gasket and cap as shown in Figure. Tighten cap to 41 N.m (30 ft. lbs.).
scientia non olet · About LEMON Manuals