LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (2.4L DOHC Engine (Service Information) - Except Coupe) >> Balance Shafts And Carrier Assembly >> Removal >> Balance Shaft Carrier

Balance Shaft Carrier

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The following components will remain intact during carrier removal: Gear cover, gears, balance shafts and the rear cover. See Figure.

  1. Drain engine oil.
  2. Remove the oil pan and pick-up tube (Refer to ENGINE/LUBRICATION/OIL PAN - REMOVAL)  .
  3. Remove chain cover, guide and tensioner. See Figure.
  4. Remove screw retaining balance shaft drive sprocket. See Figure.
  5. Move balance shaft inboard through drive chain sprocket. Sprocket will hang in lower chain loop.
  6. Remove carrier to crankcase attaching bolts to remove carrier.
scientia non olet · About LEMON Manuals