LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (2.4L DOHC Engine (Service Information) - Except Coupe) >> Air Cleaner Housing >> Removal

Air Cleaner Housing: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Disconnect inlet air temperature sensor electrical connector.
  3. Disconnect fresh air makeup hose from throttle body air inlet hose.
  4. Loosen hose clamp at throttle body air inlet hose. Remove hose from throttle body. See Fig 1.
    Fig 1: Air Cleaner Housing
    GC0032010Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove push pin securing air duct to upper radiator support.
  6. Remove nut on bracket that holds air cleaner housing.
  7. Pull air cleaner housing straight up off locating pins. See Fig 1.
scientia non olet · About LEMON Manuals