LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (2.0L DOHC Engine (Service Information) - Except Coupe) >> Vibration Damper >> Installation

Vibration Damper: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install crankshaft vibration damper using M12 1.75 x 150 mm bolt, washer, thrust bearing and nut from Special Tool 6792. See Fig 1.
  2. Install crankshaft vibration damper bolt and tighten to 136 N.m (100 ft. lbs.).
  3. Install accessory drive belts (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
  4. Raise engine with screw jack enough to install front and rear engine mount through bolts. Torque fasteners to 61 N.m (45 ft. lbs.).
  5. Install belt splash shield and right front wheel.
  6. Lower vehicle.
  7. Support engine under oil pan with wooden block and floor jack.
  8. Slowly raise engine with floor jack until engine mount bracket aligns with right side engine mount. Install three vertical bolts to front engine bracket. Torque fasteners to 61 N.m (45 ft. lbs.).
  9. Remove floor jack.
  10. Connect negative battery cable.
Fig 1: Vibration Damper - Installation
GC0032054Courtesy of DAIMLERCHRYSLER CORP.
1 - M12-1.75 x 150 MM BOLT, WASHER AND THRUST BEARING FROM SPECIAL TOOL 6792
scientia non olet · About LEMON Manuals