LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (2.0L DOHC Engine (Service Information) - Except Coupe) >> Right Mount >> Removal

Right Mount: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove coolant recovery container (Refer to COOLING/ENGINE/COOLANT RECOVERY CONTAINER - REMOVAL) .
  2. Remove heater tube front attaching screw.
  3. Raise vehicle on a hoist and remove inner splash shield.
  4. Remove heater tube rear attaching screw.
  5. Remove the right engine support assembly vertical fasteners from frame rail. See Fig 1.
  6. Lower vehicle. Remove the load on the engine motor mounts by carefully supporting the engine assembly with floor jack and wooden block on oil pan.
  7. Remove the bolts attaching the engine support assembly to the engine bracket. See Fig 1.
  8. Remove right engine mount.
Fig 1: Engine Mounting-Right Side
GC0032057Courtesy of DAIMLERCHRYSLER CORP.
1 - ENGINE SUPPORT BRACKET
2 - FRAME RAIL
3 - RIGHT ENGINE MOUNT
scientia non olet · About LEMON Manuals