Standard Procedure - Piston Ring - Fitting

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore. The ring gap measurement must be made with the ring positioned below normal ring travel in the cylinder bore. Check gap with feeler gauge. See Fig 1. For piston ring specifications (Refer to ENGINE - SPECIFICATIONS) .

Fig 1: Piston Ring Gap
Courtesy of DAIMLERCHRYSLER CORP.

1 - FEELER GAUGE

Fig 2: Piston Ring Side Clearance
Courtesy of DAIMLERCHRYSLER CORP.

1 - FEELER GAUGE
Check piston ring to groove side clearance. See Fig 2. For piston ring specifications (Refer to ENGINE - SPECIFICATIONS) .