LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (2.0L DOHC Engine (Service Information) - Except Coupe) >> Oil Pressure Sensor/Switch >> Removal

Oil Pressure Sensor/Switch: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle.
  2. Position oil collecting container under pressure switch location.
  3. Disconnect oil pressure switch electrical connector and remove switch. See Fig 1.
Fig 1: Locating Oil Pressure Switch
GC0021119Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals