LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (2.0L DOHC Engine (Service Information) - Except Coupe) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Check oil pressure using a gauge at oil pressure switch location.

  1. Remove oil pressure switch.
  2. Install oil pressure test gauge assembly C-3292 with adaptor 8406. For Special Tool identification, (Refer to ENGINE - SPECIAL TOOLS) .
    CAUTION: If oil pressure is 0 at idle, Do Not Run engine at 3000 RPM.
  3. Warm engine to normal operating temperature.
  4. Monitor gauge readings at idle and 3000 RPM. Oil Pressure: Idle  25 kPa (4 psi) minimum, 3000 RPM  170-550 kPa (25-80 psi).
  5. If oil pressure is 0 at idle, shut off engine and check the following:
    1. Pressure relief valve stuck open
    2. Clogged oil pick-up screen
    3. Damaged oil pick-up tube O-ring
scientia non olet · About LEMON Manuals