LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Exhaust System - Except Coupe) >> Resonator/Pipe Assembly >> Installation

Resonator/Pipe Assembly: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Always work from the front to rear of exhaust system when aligning and tightening exhaust system components.
  1. Loosely install resonator/pipe assembly and muffler/pipe assembly.
  2. Install support isolators to muffler supports.
  3. Align resonator/pipe assembly and muffler/pipe assembly to maintain position and proper clearance with underbody parts. All support isolators should have equal load on them. Tighten resonator/pipe assembly band clamp to 54 N.m (40 ft. lbs.).
  4. Tighten muffler/pipe assembly band clamp to 54 N.m (40 ft. lbs.).
  5. Connect ground strap to muffler.
  6. Lower vehicle.
  7. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
  8. Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.
scientia non olet · About LEMON Manuals