Diagnosis And Testing - Exhaust System Restriction Check
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Exhaust system restriction can be checked by measuring back pressure using the DRB III(R) and PEP module pressure tester.
WARNING:
THE NORMAL OPERATING TEMPERATURE OF THE EXHAUST SYSTEM IS VERY HIGH. THEREFORE, NEVER WORK AROUND OR ATTEMPT TO SERVICE ANY PART OF THE EXHAUST SYSTEM UNTIL IT IS COOLED. SPECIAL CARE SHOULD BE TAKEN WHEN WORKING NEAR THE CATALYTIC CONVERTER. THE TEMPERATURE OF THE CONVERTER RISES TO A HIGH LEVEL AFTER A SHORT PERIOD OF ENGINE OPERATION TIME.
- Disconnect and remove the upstream (before catalytic converter) oxygen sensor. Refer to O2 SENSOR .
- Install the Exhaust Back Pressure Fitting Adaptor CH8519.
- Connect the Low Pressure Sensor (15 psi) CH7063 to the back pressure fitting.
- Following the PEP module instruction manual, connect all required cables to the DRB III(R) and PEP module. Select the available menu options on the DRB III(R) display screen for using the digital pressure gauge function.
- Apply the park brake and start the engine.
- With transmission in Park or Neutral, raise engine speed to 2000 RPM. Monitor the pressure readings on the DRBIII(R). Back pressure should not exceed specified limit. Refer to specifications in EXHAUST BACK PRESSURE LIMITS table.NOTE: For applications with dual catalytic converters, repeat test on opposite converter using the previous steps.
- If pressure exceeds maximum limits, inspect exhaust system for restricted component. For further catalytic converter inspection procedures, (Refer to EXHAUST SYSTEM/CATALYTIC CONVERTER - INSPECTION) . Replace component(s) as necessary.
EXHAUST BACK PRESSURE LIMITS
| Exhaust Back Pressure Limit (Max) | |
| Vehicle in Park/Neutral (no load) @2000 RPM | 3.45 kPa (0.5 psi) |