Exhaust Pipe - Cross-Under Pipe To Resonator Pipe - 2.7L: Installation
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Always work from the front to rear of exhaust system when aligning and tightening exhaust system components.
- Loosely attach exhaust pipe to cross-under pipe.
- Loosely install resonator/pipe and muffler/pipe assembly to exhaust pipe.
- Install support isolators to muffler supports.
- Align exhaust pipe and resonator/muffler pipe assembly to maintain position and proper clearance with underbody parts. All support isolators should have equal load on them. Tighten fasteners attaching exhaust pipe to cross-under pipe to 28 N.m (250 in. lbs.).
- Tighten resonator/pipe assembly band clamp to 54 N.m (40 ft. lbs.).
- Connect ground strap to muffler.
- Lower vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
- Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.