Catalytic Converter - 2.0L/2.4L: Description
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
The under-floor, three-way catalytic converter inlet is connected to the exhaust manifold by use of a flex joint and gasket. The outlet connects to the exhaust system.
CAUTION:
When servicing, care must be exercised not to dent or bend the bellows or bellows cover of the flex-joint. Should this occur, the flex-joint will eventually fail and require the catalytic converter be replaced.
An exhaust flex-joint coupling is used to secure the catalytic converter to the engine manifold. See Fig 1.
The exhaust flex-joint is welded to the catalytic converter.
| 1 - BELLOWS |
| 2 - COVER |
| 3 - FLANGE |