Section 63 (Wiring Diagram Information): Terminal: Installation

WARNING: This page is about a different car, the 2005 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Select a wire from the terminal repair kit that best matches the color and gage of the wire being repaired.
Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation.
Splice the repair wire to the wire harness (see WIRE SPLICING procedure) .
Insert the repaired wire into the connector.
Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
Re-tape the wire harness starting at 1-1/2 inches behind the connector and 2 inches past the repair.
Connect battery and test all affected systems.