LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Wiring Diagram Information) >> Diode >> Installation

Section 63 (Wiring Diagram Information): Diode: Installation

WARNING: This page is about a different car, the 2005 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the insulation from the wires in the harness. Only remove enough insulation to solder in the new diode.
  2. Install the new diode in the harness, making sure current flow is correct. If necessary, refer to SYSTEM WIRING DIAGRAMS for current flow. See Figure.
  3. Solder the connection together using rosin core type solder only. Do not use acid core solder. 
  4. Tape the diode to the harness using electrical tape. Make sure the diode is completely sealed from the elements.
  5. Re-connect the battery and test affected systems.
scientia non olet · About LEMON Manuals