Section 63 (Wiring Diagram Information): Connector: Installation

WARNING: This page is about a different car, the 2005 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Insert the removed terminal in the same cavity on the repair connector.
Repeat steps for each terminal in the connector, being sure that all wires are inserted into the proper cavities. For additional connector pin-out identification, refer to SYSTEM WIRING DIAGRAMS .
When the connector is re-assembled, the secondary terminal lock must be placed in the locked position to prevent terminal push out.
Replace dress cover (if applicable).
Connect connector to its mating half/component.
Connect battery and test all affected systems.