Fastener Tightening Specifications
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION | |
|---|---|---|
| Exhaust fitting stay (LH) | M8 | 22 +/- 4 N.m (16 +/- 3 ft-lb) |
| M12 | 32 +/- 7 N.m (24 +/- 5 ft-lb) | |
| Exhaust fitting stay (RH) | M8 | 22 +/- 4 N.m (16 +/- 3 ft-lb) |
| M12 | 32 +/- 7 N.m (24 +/- 5 ft-lb) | |
| Warm up three way catalytic converter (LH) nut | 35 +/- 4 N.m (26 +/- 3 ft-lb) | |
| Warm up three way catalytic converter (RH) nut | 35 +/- 4 N.m (26 +/- 3 ft-lb) | |
| Front exhaust pipe nut < 2.4L ENGINE > | 49 +/- 10 N.m (37 +/- 7 ft-lb) | |
| Front exhaust pipe to center exhaust pipe nut | 59 +/- 10 N.m (44 +/- 7 ft-lb) | |
| Front exhaust pipe to warm up three way catalytic converter nut < 3.0L ENGINE > | 49 +/- 9 N.m (37 +/- 6 ft-lb) | |
| Hanger bolt | 12 +/- 2 N.m (107 +/- 17 in-lb) | |
| Heated oxygen sensor (rear) | 54 +/- 5 N.m (40 +/- 4 ft-lb) | |
| Left bank heated oxygen sensor (rear) | 54 +/- 5 N.m (40 +/- 4 ft-lb) | |
| Right bank heated oxygen sensor (front) | 54 +/- 5 N.m (40 +/- 4 ft-lb) | |
| Right bank heated oxygen sensor (rear) | 54 +/- 5 N.m (40 +/- 4 ft-lb) | |