LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Diagnosis - Automatic Transmission - Coupe) >> Transaxle Control >> Removal And Installation >> Installation Service Point >> >> C << Nut Installation

>> C << Nut Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the transaxle manual control lever in the "N" position.
  2. Place the selector lever in the "N" position.
  3. Place the cable stud into the manual control lever slot and install the nut loosely. Gently push the transaxle control cable in the direction of the arrow until the cable is taut. Tighten the nut to the specified torque.

    Tightening torque: 12 +/- 2 N.m (102 +/- 22 in-lb) 

    Fig 1: Installing Nut
    G04542581Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals