LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Diagnosis - Automatic Transmission - Coupe) >> Automatic Transaxle Diagnosis >> Diagnostic Trouble Code Procedures >> LOGIC FLOW CHARTS (Monitor Sequence) >> OBD-II Drive Cycle Pattern

OBD-II Drive Cycle Pattern

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Start the engine, drive at 60 km/h (37 mph) or more for 15 minutes in total.



Start the engine, shift to 3rd gear or higher, and drive at 40 km/h (25 mph) or more for 10 seconds.



Start the engine, and drive for 5 seconds, with 1st gear fixed (L range or 1st gear in sport mode), at 20 km/h (12 mph) or more with 50% or more of accelerator pedal depressing. Then stop the vehicle, and drive again for 5 seconds, with 1st gear fixed (L range or 1st gear in sport mode), at 20 km/h (12 mph) or more with 50% or more of accelerator pedal depressing.



Start the engine, keep the vehicle stopped in "P," "R," "N," "D," "3," "2" and "L" ranges respectively for more than one minute, and turn OFF the ignition switch. Then restart the engine, and stop the vehicle in "P," "R," "N," "D," "3," "2" and "L" ranges respectively for more than one minute.



Start the engine, keep the vehicle stopped in "P," "R," "N," "D," "3," "2" and "L" ranges respectively for more than one minute, and turn OFF the ignition switch. Then restart the engine, and stop the vehicle in "P," "R," "N," "D," "3," "2" and "L" ranges respectively for more than one minute.



Start the engine, and keep the vehicle stopped in "P" range for 5 seconds.



Start the engine, and keep the vehicle stopped in "P" range for 5 seconds.



Start the engine, and keep the vehicle stopped in P range for 5 seconds.



Start the engine, and keep the vehicle stopped in "P" range for 5 seconds.



Start the engine, and keep the vehicle stopped in "P" range for 5 seconds.



Start the engine, and drive at 100 km/h (62 mph) for 10 seconds. Then stop the vehicle, and turn OFF the ignition switch. After that, restart the engine, and drive again at 100 km/h (62 mph) for 10 seconds.



Start the engine, and drive at 30 km/h (19 mph) for 30 seconds. Then stop the vehicle, and turn "LOCK" (OFF) the ignition switch. After that, restart the engine, and drive again at 30 km/h (19 mph) for 30 seconds.



Start the engine, and keep the vehicle stopped in "P" range for 5 seconds.