Inspection Using Scan Tool, Road Test And Data List
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Required Special Tool:
MB991502: Scan Tool (MUT-II)
CAUTION:
To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991502.
- Connect scan tool MB991502 to the data link connector.
- Turn the ignition switch to the "ON" position.
- Carry out the inspection by means of the Road Test and the Data List function. If there is an abnormality, check and repair the chassis harnesses and components. Refer to , ROAD TEST . Refer to , DATA LIST REFERENCE TABLE .
- Re-check using scan tool MB991502 and confirm that the abnormal input and output have returned to normal as a result of the repairs.
- Check for and inspect any diagnostic trouble codes (DTCs) that may have surfaced from testing. Erase any diagnostic trouble codes after checking.
- Turn the ignition switch to the "LOCK" (OFF) position.
- Disconnect scan tool MB991502 from the data link connector.
- Start the engine again and do a test drive to confirm that the problem is eliminated.