Actuator Test Reference Table
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
ACTUATOR TEST REFERENCE
| MUT-II SCAN TOOL DISPLAY | ITEM NO. | INSPECTION ITEM | TEST CONTENT | INSPECTION REQUIREMENT | NORMAL CONDITION |
|---|---|---|---|---|---|
| 1st SIFT LMP | 07 | 1st indicator light < Vehicles with sport mode > | Illuminate each indicator light for three to the signal from the MUT-II |
|
Shift indicator light illuminates |
| 2nd SIFT LMP | 08 | 2nd indicator light < Vehicles with sport mode > | |||
| 2ND SOL | 03 | Second solenoid valve | Drive the solenoid valve specified by the scan tool (MUT-II) at 50% duty for five seconds. No other solenoid valve should be energized. | The solenoid should click when activated | |
| 3rd SIFT LMP | 09 | 3rd indicator light < Vehicles with sport mode > | Illuminate each indicator light for three to the signal from the MUT-II | Shift indicator light illuminates | |
| 4th SIFT LMP | 10 | 4th indicator light < Vehicles with sport mode > | |||
| A/T RELAY | 12 | A/T control relay | Actuator test in scope mode, data list No. 54. Control relay is OFF for three seconds. | Data list No. 54
|
|
| L/R SOL | 01 | Low-reverse solenoid valve | Drive the solenoid valve specified by the scan tool (MUT-II) at 50% duty for five seconds. No other solenoid valve should be energized. | The solenoid should click when activated | |
| O/D SOL | 04 | Overdrive solenoid valve | |||
| TCC SOL | 06 | Torque converter clutch solenoid valve | |||
| U/D SOL | 02 | Underdrive solenoid valve |