LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Overhaul - Coupe) >> Transaxle (Transmission) >> Disassembly And Assembly >> Assembly Service Points >> >> M << Select Lever Installation

>> M << Select Lever Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply grease (Mitsubishi Genuine Part number 0101011 or equivalent) to the control shaft sliding portion of the select lever shoe.
  2. Install the select lever and tighten the bolts to specified torque.

    Tightening torque: 19 +/- 3 N.m (14 +/- 2 ft-lb) 

    Fig 1: Applying Grease To Control Shaft Sliding Portion Of Select Lever Shoe
    G04541605Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals