LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Overhaul - Coupe) >> Transaxle (Transmission) >> Disassembly And Assembly >> Assembly Service Points >> >> J << Under Cover Installation

>> J << Under Cover Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Squeeze out the sealant uniformly, while making sure that it is not broken or excessively applied.
  1. Apply a 2 mm (0.08 inch) diameter bead of sealant (Mitsubishi Genuine Part number MD997740 or equivalent) to the illustrated position of the transaxle case.
    NOTE: .Be sure to install the case quickly while the sealant is wet (within 15 minutes).
  2. Install the under cover to the transaxle case and tighten the bolts to specified torque.

    Tightening torque: 7 +/- 1 N.m (61 +/- 9 in-lb) 

    NOTE: . After installation, keep the sealed area away from the oil for approximately one hour.
    Fig 1: Installing Under Cover To Transaxle Case
    G04541602Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals