Fastener Tightening Specifications
WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
ITEM SPECIFICATIONS
| ITEMS | SPECIFICATIONS |
|---|---|
| Roll stopper bracket mounting bolt | 69 +/- 10 N.m (51 +/- 7 ft-lb) |
| Shift cable bracket mounting bolt | 19 +/- 3 N.m (14 +/- 2 ft-lb) |
| Select lever mounting bolt | 19 +/- 3 N.m (14 +/- 2 ft-lb) |
| Speedometer gear mounting bolt | 4 +/- 1 N.m (35 +/- 9 in-lb) |
| Backup light switch | 32 +/- 2 N.m (24 +/- 1 ft-lb) |
| Interlock plate bolt | 30 +/- 3 N.m (22 +/- 2 ft-lb) |
| Poppet spring | 32 +/- 2 N.m (24 +/- 1 ft-lb) |
| Control housing mounting bolt | 19 +/- 3 N.m (14 +/- 2 ft-lb) |
| Under cover mounting bolt | 7 +/- 1 N.m (61 +/- 9 in-lb) |
| Reverse idler gear shaft mounting bolt | 48 +/- 6 N.m (35 +/- 4 ft-lb) |
| Clutch housing-transaxle case mounting bolt | 44 +/- 5 N.m (33 +/- 4 ft-lb) |
| Front bearing retainer mounting bolt < F5M42 > | 19 +/- 3 N.m (14 +/- 2 ft-lb) |
| Select lever mounting nut | 12 +/- 1 N.m (104 +/- 9 in-lb) |
| Stopper bracket mounting bolt | 25 +/- 3 N.m (19 +/- 2 ft-lb) |
| Clutch release bearing retainer mounting bolt | 9.8 +/- 2 N.m (87 +/- 17 in-lb) |
| Differential drive gear mounting bolt | 132 +/- 5 N.m (98 +/- 4 ft-lb) |