LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Overhaul - Coupe) >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> O << Synchronizer Ring Installation

>> O << Synchronizer Ring Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: There is a 5th speed synchronizer ring and a reverse synchronizer ring. Be careful not to confuse the two when installing, as a mistake can effect the shift feeling.
  1. Check for the presence of identification notches on the synchronizer ring.

    No notches: 5th speed synchronizer ring 

    Six notches: Reverse synchronizer ring < F5M42 > 

    Three notches: Reverse synchronizer ring < F5M51 > 

  2. Install the synchronizer ring so that it does not incline toward the cone of the gear.
    Fig 1: Checking Presence Of Identification Notches On Synchronizer Ring
    G04541673Courtesy of DAIMLERCHRYSLER CORP.