LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Overhaul - Coupe) >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> K << Snap Ring Installation

>> K << Snap Ring Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the thickest snap ring that can be fitted in the groove of output shaft.
  2. Make sure that the 3rd speed gear end play meets the standard value.

    Standard value: 0 - 0.09 mm (0 - 0.0035 inch) 

    Fig 1: Installing Thickest Snap Ring
    G04541667Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals