>> G << 1ST-2ND Speed Synchronizer Hub Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.

Set the output shaft on the press support stand.
Check that the 1st-2nd speed synchronizer hub is in the correct installation direction, and put it on the output shaft.
Using special tools MD998812, MD998814, MD998825 < F5M42 >, MD998824 < F5M51 > and MD998364 < F5M51 >, press install the 1st-2nd speed synchronizer hub with the press.
Make sure that the outer synchronizer ring on the 1st speed gear side can rotate freely.

Fig 1: Identifying Installation Direction (F5M42)
Courtesy of DAIMLERCHRYSLER CORP.

Fig 2: Identifying Installation Direction (F5M51)
Courtesy of DAIMLERCHRYSLER CORP.

Fig 3: Installing 1st-2nd Speed Synchronizer Hub (F5M42)
Courtesy of DAIMLERCHRYSLER CORP.

Fig 4: Installing 1st-2nd Speed Synchronizer Hub (F5M51)
Courtesy of DAIMLERCHRYSLER CORP.