LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Overhaul - Coupe) >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> M << Snap Ring Installation

>> M << Snap Ring Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the thickest snap ring that can be fitted in the groove of input shaft.
  2. Make sure that the ball bearing end play meet the standard value.

    Standard value: 0 - 0.12 mm (0 - 0.0047 inch) 

    Fig 1: Installing Thickest Snap Ring
    G04541630Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals