LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Overhaul - Coupe) >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> G << Synchronizer Sleeve Installation

>> G << Synchronizer Sleeve Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the installation direction of the synchronizer sleeve, and install it onto the 3rd-4th speed synchronizer hub.
    Fig 1: Checking Installation Direction Of Synchronizer Sleeve
    G04541622Courtesy of DAIMLERCHRYSLER CORP.
  2. Install the synchronizer sleeve so that the areas with teeth that have raised tips (three areas total) are aligned with the areas on the synchronizer hub that have deep grooves between the teeth (three areas total).
    Fig 2: Installing Synchronizer Sleeve
    G04541623Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals